Kannst du bitte Output von /proc/cpuinfo postenHomoran hat geschrieben:Mein normaler BananaPi mit Armbian wird als Olimex micro erkannt
Code: Alles auswählen
root@bananapipro:~# echo $BOARD_TYPE $BOARD_VERSION Olimex Micro
Gruß
Rainer
ARM Board Erkennung (Bitte Skript testen)
Moderator: Co-Administratoren
Re: ARM Board Erkennung (Bitte Skript testen)
Re: ARM Board Erkennung (Bitte Skript testen)
Hat was gedauert,, da lief gerade die YAHM-Installation
Gruß
Rainer
Code: Alles auswählen
Processor : ARMv7 Processor rev 4 (v7l)
processor : 0
BogoMIPS : 956.30
processor : 1
BogoMIPS : 959.75
Features : swp half thumb fastmult vfp edsp neon vfpv3 tls vfpv4 idiva idivt
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xc07
CPU revision : 4
Hardware : sun7i
Revision : 0000
Serial : 1651661007c109e4
Chipid : 16516610-80485278-50554848-07c109e4
Rainer
Alle meine Hinweise sind auf eigene Gefahr umzusetzen. Immer einen Fachmann zu Rate ziehen!
Re: ARM Board Erkennung (Bitte Skript testen)
Cubox i4 klappt jetzt mit dem Original image von SolidRun
dafür komme ich jetzt mit dem Vanilla nicht mit SSH auf den BananaPi
Auf ein neues!
Gruß
Rainer
Code: Alles auswählen
root@Kuh-Box:~# source ./armhwinfo.sh
root@Kuh-Box:~# echo $BOARD_TYPE $BOARD_VERSION
Cubox i4
Auf ein neues!
..klappt leider nicht ganz so einfachleonsio hat geschrieben:Falls es nicht so viel mühe macht, würde ich es mit möglichst viel HW testen
Gruß
Rainer
Alle meine Hinweise sind auf eigene Gefahr umzusetzen. Immer einen Fachmann zu Rate ziehen!
Re: ARM Board Erkennung (Bitte Skript testen)
glaube ich dir, schraube gerade meinen Pi3 in den Schaltschrank zurück, ist bei mir auch recht viel Aufwand
-
- Beiträge: 395
- Registriert: 27.06.2014, 21:50
Re: ARM Board Erkennung (Bitte Skript testen)
Richtig erkannt:
Raspberry Pi 2
Die Variante (B, B+ usw) wurde nicht mit ausgegeben.
Raspberry Pi 2
Die Variante (B, B+ usw) wurde nicht mit ausgegeben.
370 Kanäle in 119 Geräten und 22 CUxD-Kanäle in 18 CUxD-Geräten, dazu ioBroker und diverse weitere eingebundene Systeme, vom 433MHz Bewegungsmelder bis hin zur Wallbox.
-
- Beiträge: 14
- Registriert: 29.04.2016, 19:18
Re: ARM Board Erkennung (Bitte Skript testen)
Banana Pro
root@bananapi ~ # echo $BOARD_TYPE $BOARD_VERSION
Olimex Micro
Gruß Frank
root@bananapi ~ # echo $BOARD_TYPE $BOARD_VERSION
Olimex Micro
Code: Alles auswählen
Processor : ARMv7 Processor rev 4 (v7l)
processor : 0
BogoMIPS : 1195.38
processor : 1
BogoMIPS : 1199.69
Features : swp half thumb fastmult vfp edsp neon vfpv3 tls vfpv4 idiva idivt
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xc07
CPU revision : 4
Hardware : sun7i
Revision : 0000
Serial : 0542e6f75448484880485666xxxxxxxx
Re: ARM Board Erkennung (Bitte Skript testen)
welches Betriebssystem setzt du ein?
Leon265130 hat geschrieben:Banana Pro
root@bananapi ~ # echo $BOARD_TYPE $BOARD_VERSION
Olimex Micro
Gruß FrankCode: Alles auswählen
Processor : ARMv7 Processor rev 4 (v7l) processor : 0 BogoMIPS : 1195.38 processor : 1 BogoMIPS : 1199.69 Features : swp half thumb fastmult vfp edsp neon vfpv3 tls vfpv4 idiva idivt CPU implementer : 0x41 CPU architecture: 7 CPU variant : 0x0 CPU part : 0xc07 CPU revision : 4 Hardware : sun7i Revision : 0000 Serial : 0542e6f75448484880485666xxxxxxxx
Re: ARM Board Erkennung (Bitte Skript testen)
Hallo Leo,
nach langer Abstinenz habe ich wieder etwas neues getestet.
ASUS Tinkerboard mit Broadcom rk3288, ARM Cortex A17 Quad
Gruß
Rainer
nach langer Abstinenz habe ich wieder etwas neues getestet.
ASUS Tinkerboard mit Broadcom rk3288, ARM Cortex A17 Quad
Code: Alles auswählen
linaro@linaro-alip:~$ source ./armhwinfo.sh
linaro@linaro-alip:~$ echo $BOARD_TYPE $BOARD_VERSION
linaro@linaro-alip:~$
Gruß
Rainer
Alle meine Hinweise sind auf eigene Gefahr umzusetzen. Immer einen Fachmann zu Rate ziehen!
Re: ARM Board Erkennung (Bitte Skript testen)
kannst du bitte Output von den Befehlen posten, dann werde ich die Unterstützung erweitern (oder zumindest versuchen)
Code: Alles auswählen
lscpu
cat /proc/cpuinfo
cat /proc/meminfo
cat /proc/device-tree/model
Re: ARM Board Erkennung (Bitte Skript testen)
aber immer doch:leonsio hat geschrieben:kannst du bitte Output von den Befehlen posten
Code: Alles auswählen
linaro@linaro-alip:~$ lscpu
Architecture: armv7l
Byte Order: Little Endian
CPU(s): 4
On-line CPU(s) list: 0-3
Thread(s) per core: 1
Core(s) per socket: 4
Socket(s): 1
Model name: ARMv7 Processor rev 1 (v7l)
CPU max MHz: 1800.0000
CPU min MHz: 126.0000
Code: Alles auswählen
linaro@linaro-alip:~$ cat /proc/cpuinfo
processor : 0
model name : ARMv7 Processor rev 1 (v7l)
BogoMIPS : 12.09
Features : half thumb fastmult vfp edsp thumbee neon vfpv3 tls vfpv4 idiva idivt vfpd32 lpae evtstrm
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xc0d
CPU revision : 1
processor : 1
model name : ARMv7 Processor rev 1 (v7l)
BogoMIPS : 12.09
Features : half thumb fastmult vfp edsp thumbee neon vfpv3 tls vfpv4 idiva idivt vfpd32 lpae evtstrm
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xc0d
CPU revision : 1
processor : 2
model name : ARMv7 Processor rev 1 (v7l)
BogoMIPS : 12.09
Features : half thumb fastmult vfp edsp thumbee neon vfpv3 tls vfpv4 idiva idivt vfpd32 lpae evtstrm
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xc0d
CPU revision : 1
processor : 3
model name : ARMv7 Processor rev 1 (v7l)
BogoMIPS : 12.09
Features : half thumb fastmult vfp edsp thumbee neon vfpv3 tls vfpv4 idiva idivt vfpd32 lpae evtstrm
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xc0d
CPU revision : 1
Hardware : Rockchip (Device Tree)
Revision : 0000
Serial : 0000000000000000
Code: Alles auswählen
linaro@linaro-alip:~$ cat /proc/meminfo
MemTotal: 2063768 kB
MemFree: 127484 kB
MemAvailable: 1290460 kB
Buffers: 121608 kB
Cached: 913176 kB
SwapCached: 0 kB
Active: 1132840 kB
Inactive: 548204 kB
Active(anon): 646916 kB
Inactive(anon): 51000 kB
Active(file): 485924 kB
Inactive(file): 497204 kB
Unevictable: 0 kB
Mlocked: 0 kB
HighTotal: 1310720 kB
HighFree: 86224 kB
LowTotal: 753048 kB
LowFree: 41260 kB
SwapTotal: 0 kB
SwapFree: 0 kB
Dirty: 48 kB
Writeback: 0 kB
AnonPages: 646400 kB
Mapped: 95316 kB
Shmem: 51656 kB
Slab: 215944 kB
SReclaimable: 198844 kB
SUnreclaim: 17100 kB
KernelStack: 3424 kB
PageTables: 8052 kB
NFS_Unstable: 0 kB
Bounce: 0 kB
WritebackTmp: 0 kB
CommitLimit: 1031884 kB
Committed_AS: 3005044 kB
VmallocTotal: 245760 kB
VmallocUsed: 0 kB
VmallocChunk: 0 kB
CmaTotal: 131072 kB
CmaFree: 68304 kB
Code: Alles auswählen
linaro@linaro-alip:~$ cat /proc/device-tree/model
cat: /proc/device-tree/model: No such file or directory
Gruß
Rainer
Alle meine Hinweise sind auf eigene Gefahr umzusetzen. Immer einen Fachmann zu Rate ziehen!