Hi All,
Was wondering if anyone has had any success making direct connections between the HMip-SLO and light actuators ?
I am able to setup a direct connection ok using WebUI in CCU3 but it never works. i.e. lights are not turned on and off based on lux settings in channel 2 or 3. (condition switches)
I can however create a program and that works fine but I really need this to work even if CCU3 is down or off.
Kind thanks,
Serge
HMip-SLO and Direct Connections not working
Moderator: Co-Administratoren
- Baxxy
- Beiträge: 11304
- Registriert: 18.12.2018, 15:45
- System: Alternative CCU (auf Basis OCCU)
- Hat sich bedankt: 662 Mal
- Danksagung erhalten: 2403 Mal
Re: HMip-SLO and Direct Connections not working
Please show screenshots from the HmIP-SLO configuration and from your direct-connection.
And please precise "light actuators". (PSM / BDT / etc.)
And please precise "light actuators". (PSM / BDT / etc.)
Grüße... Baxxy
- Raspberry Pi 4 als Homematic-Zentrale - Tipps und Informationen
- Analysescript für genutzte Funk-Adressen, Funkmodul-Hardware und Zentralen Hardware
- NANO CUL 868MHz - Stick zum AskSin Analyzer XS umflashen (Anleitung für ArduinoIDE unter Windows)
- Firmware Updates für IP-Aktoren / Sensoren... Info's, Tipps und Sonstiges
- CCU funkt nicht - CarrierSense (CS) Probleme erkennen und lösen