HmIP-FAL230-C10 Emergency operation

[samuellazea]

Hello friends,

I have a strange situation. I have a FAL230-C10 with multiple WTH connected to it and a FAL230-C6 with multiple WTH connected to it. The FAL230-C6 is behaving ok without issues while the FAL230-C10 I see the channel 1 ( Pump ) misbehaving. I want to mention that I configured channel 1 as a valve and not a Pump and have no WTH connected to channel 1 and 10.

Now I have the exact configuration on FAL230-C6 and that one is ok.
On the FAL230-C10 I see the channel 1 led always blinking. Checking on the problems I see this in CCU

Basically he is reporting connection lost with room thermostat but I don't have any WTH configured for this channel.
I also try to debug by looking at homeassistant for more information and in there I see this

I also tried to even add a WTH to channel 1 but it did not change anything. I also made sure that all WTH connected to this FAL have connections by going to all and changing the temperature setpoint and they reported the green led light that means all is accepted.

At this point I don't know what else can I do to get out from the emergency operation cause this is creating problems on how the valve actors work. This is changing the operation times of the valves.

Is there anything I could still check or configure to get out of this emergency operation?

Thank you lots in advance

[samuellazea]

I did more observing over 24 hours and here it's the result

The red marked are from FAL230-C10
The blue marked are from FAL230-C6