HM-CC-RT-DN valve position optimisation

Support for our english speaking visitors

Moderator: Co-Administratoren

Antworten
Dolph
Beiträge: 16
Registriert: 16.09.2013, 22:37

HM-CC-RT-DN valve position optimisation

Beitrag von Dolph » 23.03.2015, 00:24

Is it possible to reset the self calibration these do?

I previously had my heating set to trigger when any valve exceeded 20%. I've now pushed that up to 30% as i found it recycling a bit too much at 20.

Unfortunately a couple of the valves, particularly those that would often be open on their own, seem to "stick" in the low 20's even when the recorded temperature is some way below the set temp, presumable because preciously this would be enough to heat the room but now means the heating doesn't come on.

Would like to reset the calibration and hopefully without having to re-teach all the components!

Antworten

Zurück zu „HomeMatic - english“