Hi forum
Henrik from Denmark here.
Using the CCU2 and thermostats on my heating system. I will get a new circulating low heat system soon, but until that i have water temp. in the radiators of up-to 70dgr.
This result in massive overheating of the rooms before the thermostat close the waterflow. I have seen, that it is possible to limit the valve opening by a percentage using booster, but i would really like to be able to limit the opening at all time.
If i could set for each thermostat, that for instance 10% opening is max. it could solve my problem.
Are there any parameter somewhere in the system for that?
Best regards
Henrik - Denmark
Valve opening %
Moderator: Co-Administratoren
- Roland M.
- Beiträge: 9778
- Registriert: 08.12.2012, 15:53
- System: CCU
- Wohnort: Graz, Österreich
- Hat sich bedankt: 252 Mal
- Danksagung erhalten: 1369 Mal
Re: Valve opening %
Hello Henrik,
yes, you can limit the valve opening of the thermostat.
To do this, you first have to clear the "expert mode not visible" checkbox at the user account configuration.
With the expert mode enabled, you'll find the "Max. valve opening" setting in the device settings.
Roland
yes, you can limit the valve opening of the thermostat.
To do this, you first have to clear the "expert mode not visible" checkbox at the user account configuration.
With the expert mode enabled, you'll find the "Max. valve opening" setting in the device settings.
Roland
Zur leichteren Hilfestellung bitte unbedingt beachten:
-----------------------------------------------------------------------
1. CCU2 mit ~100 Geräten (in Umstellung auf RaspberryMatic-OVA auf Proxmox-Server)
2. CCU2 per VPN mit ~50 Geräten (geplant: RaspberryMatic auf Charly)
3. CCU2 per VPN mit ~40 Geräten (geplant: RaspberryMatic auf CCU3)
CCU1, Test-CCU2, Raspi 1 mit kleinem Funkmodul, RaspberryMatic als VM unter Proxmox, Access Point,...
- Bezeichnung (HM-... bzw. HmIP-...) der betroffenen Geräte angeben (nicht Artikelnummer)
- Kurzbeschreibung des Soll-Zustandes (Was soll erreicht werden?)
- Kurzbeschreibung des Ist-Zustandes (Was funktioniert nicht?)
- Fehlermeldungen genau abschreiben, besser noch...
- Screenshots von Programmen, Geräteeinstellungen und Fehlermeldungen (direkt als jpg/png) einstellen!
-----------------------------------------------------------------------
1. CCU2 mit ~100 Geräten (in Umstellung auf RaspberryMatic-OVA auf Proxmox-Server)
2. CCU2 per VPN mit ~50 Geräten (geplant: RaspberryMatic auf Charly)
3. CCU2 per VPN mit ~40 Geräten (geplant: RaspberryMatic auf CCU3)
CCU1, Test-CCU2, Raspi 1 mit kleinem Funkmodul, RaspberryMatic als VM unter Proxmox, Access Point,...