teach in problems wall thermostat
Verfasst: 11.09.2018, 19:50
Hi All,
Today I received a 2nd wall thermostat which is going to control my floor heating in the kitchen.
Teaching doesn't seem to work… Please advice, probably i'm doing something wrong...
It's an homematic IP thermostat (HmIP-WTH-2).
It should be teached in in the CCU.
I tried both possibilities:
1.press 'teach in hmIP device' and then press button on device. Device says 'pairing'. Screen is counting down from 60 to 0 seconds. No result, device not present
2. type in Key and SGTIN, with and without '-'. Also no respond
Anybody an Idea how to find out what I'm doing wrong?
Reply in English, Dutch or German are fine!
Regards,
Remko
Today I received a 2nd wall thermostat which is going to control my floor heating in the kitchen.
Teaching doesn't seem to work… Please advice, probably i'm doing something wrong...
It's an homematic IP thermostat (HmIP-WTH-2).
It should be teached in in the CCU.
I tried both possibilities:
1.press 'teach in hmIP device' and then press button on device. Device says 'pairing'. Screen is counting down from 60 to 0 seconds. No result, device not present
2. type in Key and SGTIN, with and without '-'. Also no respond
Anybody an Idea how to find out what I'm doing wrong?
Reply in English, Dutch or German are fine!
Regards,
Remko