Seite 1 von 1
Holiday and/or party mode: how?
Verfasst: 25.01.2020, 13:00
von Huey
Hello, just starting with Homematic (IP) so there is still a lot to learn and read... So I tried finding answers to my following question but have not yet found it. So it would be great if someone had the answer or could point me to a topic where it is addressed (might even be in the German forum, reading is fine, writing/speaking less so)!
So my question:
The manual says that my HmIP-WTH-2 thermostats should be able to switch between manu, auto or a holiday or party mode. On my display I am not able to: it shows only "manu" or "auto".
My setup is with the CCU3 (with RaspberryMatic), thermostats switch a HmIP-MIOB. For my living room this controls a FALMOT-C12, others the radiators with HmIP-eTRV-2 or a electrical heater on a HmIP-PSM. All firmware latest.
So what do I miss?
Tia
Re: Holiday and/or party mode: how?
Verfasst: 25.01.2020, 13:57
von Baxxy
Huey hat geschrieben: ↑25.01.2020, 13:00
So what do I miss?
I think nothing. You can read about this here (in german).
https://de.elv.com/forum/direktverknuep ... peckt-5802
Greets
Baxxy
Re: Holiday and/or party mode: how?
Verfasst: 25.01.2020, 14:16
von Huey
Ah, ok that indeed explains. Thanks Baxxy!
So that would mean I need to create a program to get this kind of functionality and then control with a switch or maybe pocketControl, right?
Re: Holiday and/or party mode: how?
Verfasst: 25.01.2020, 14:48
von Baxxy
Huey hat geschrieben: ↑25.01.2020, 14:16
So that would mean I need to create a program to get this kind of functionality and then control with a switch or maybe pocketControl, right?
The easiest way is to use the CCU WebUI. Example:
but with your ideas it should also go. Unfortunately i have less experience in that. But i think others can help.
Greets
Baxxy
Re: Holiday and/or party mode: how?
Verfasst: 24.01.2021, 12:33
von bilbolodz
How to set holiday mode for "whole house" (I've 5 groups/rooms configured)?
Re: Holiday and/or party mode: how?
Verfasst: 24.01.2021, 12:53
von Sergo
bilbolodz hat geschrieben: ↑24.01.2021, 12:33
How to set holiday mode for "whole house" (I've 5 groups/rooms configured)?
Check if we have related global variable (cannot do right now myself). If not, create and use its value for “whole house”, to address switches in operational mode, via simple program.
Re: Holiday and/or party mode: how?
Verfasst: 24.01.2021, 13:02
von Gluehwurm
bilbolodz hat geschrieben: ↑24.01.2021, 12:33
How to set holiday mode for "whole house" (I've 5 groups/rooms configured)?
No, my solution -> a program for start at time/date -> set groups (or, when only single thermostat) in manual mode with temp. 15°. Another program for end time/date -> set groups (or ...) in Automodus.
Regards
Bruno