HmIP-eTRV-2 level control
Moderator: Co-Administratoren
HmIP-eTRV-2 level control
Hi, I am trying to directly control valve level of HmIP-eTRV-2. Thankfully the level property is writable so it can be done, but after some time, internal controller overwrites set value. Currently I circumvent this problem by sending level value every minute. Unfortunately I observe that valve starts to move and then goes back to desired level. This creates unnecessary noises and drains battery. Maybe there is some method to disable internal controller? Or to set it to react less often?
- Baxxy
- Beiträge: 10766
- Registriert: 18.12.2018, 15:45
- System: Alternative CCU (auf Basis OCCU)
- Hat sich bedankt: 602 Mal
- Danksagung erhalten: 2201 Mal
Re: HmIP-eTRV-2 level control
Don't know whether it is really possible. Have you tried to set the HmIP-eTRV-2 to "OFF" in the WebUI and then control the valve?
Grüße... Baxxy
- Raspberry Pi 4 als Homematic-Zentrale - Tipps und Informationen
- Analysescript für genutzte Funk-Adressen, Funkmodul-Hardware und Zentralen Hardware
- NANO CUL 868MHz - Stick zum AskSin Analyzer XS umflashen (Anleitung für ArduinoIDE unter Windows)
- Firmware Updates für IP-Aktoren / Sensoren... Info's, Tipps und Sonstiges
- CCU funkt nicht - CarrierSense (CS) Probleme erkennen und lösen