I'm just starting my migration from EQ3 Max! to Homematic solution (bloody EQ3 Max Cube config resets) and I've question about firmware upgrade.
So far (to test) I've bought:
- HMIP-SWDO (firmware: 1.16.
- HmIP-WTH-B (firmware: 1.0.12)
- HmIP-eTRV-B (firmware: 1.0.20)
- CCU3
Before I'll start playing with it I'd like to be sure that all my hardware have up to date firmware. Is there any information about "newest firmware for particular device". I've already upgraded CCU3 but I can't find firmware for other devices. As I said: I'm a newbie in Homematic so sorry if these question is stupid.
Firmware update - newbie question
Moderator: Co-Administratoren
- Baxxy
- Beiträge: 10779
- Registriert: 18.12.2018, 15:45
- System: Alternative CCU (auf Basis OCCU)
- Hat sich bedankt: 604 Mal
- Danksagung erhalten: 2205 Mal
Re: Firmware update - newbie question
Hi,
if your CCU3 has Internet-Access then it should show you updates (if available) for your devices on the startpage.
It looks like these...
Grüße... Baxxy
- Raspberry Pi 4 als Homematic-Zentrale - Tipps und Informationen
- Analysescript für genutzte Funk-Adressen, Funkmodul-Hardware und Zentralen Hardware
- NANO CUL 868MHz - Stick zum AskSin Analyzer XS umflashen (Anleitung für ArduinoIDE unter Windows)
- Firmware Updates für IP-Aktoren / Sensoren... Info's, Tipps und Sonstiges
- CCU funkt nicht - CarrierSense (CS) Probleme erkennen und lösen
-
- Beiträge: 13
- Registriert: 23.12.2020, 14:03
- System: CCU und Access Point
- Danksagung erhalten: 1 Mal
Re: Firmware update - newbie question
Thank you for information. Yes mu CCU3 has internet connection. Actually I've installed RaspberryMatic on it but as I understand it should be similar.
So if I've NO information on dashboard there is no new firmware and I don't have to bother with manual firmware checking, right?
So if I've NO information on dashboard there is no new firmware and I don't have to bother with manual firmware checking, right?
- Baxxy
- Beiträge: 10779
- Registriert: 18.12.2018, 15:45
- System: Alternative CCU (auf Basis OCCU)
- Hat sich bedankt: 604 Mal
- Danksagung erhalten: 2205 Mal
Re: Firmware update - newbie question
Yes right. I'm using RaspberryMatic too, there is no difference to CCU3 in firmware cheking.
Grüße... Baxxy
- Raspberry Pi 4 als Homematic-Zentrale - Tipps und Informationen
- Analysescript für genutzte Funk-Adressen, Funkmodul-Hardware und Zentralen Hardware
- NANO CUL 868MHz - Stick zum AskSin Analyzer XS umflashen (Anleitung für ArduinoIDE unter Windows)
- Firmware Updates für IP-Aktoren / Sensoren... Info's, Tipps und Sonstiges
- CCU funkt nicht - CarrierSense (CS) Probleme erkennen und lösen