Beitrag
von mototeacher » 04.03.2022, 13:02
Hi soyxan,
in my own system I'm using WTH-2, but the control functionality should be the same.
My floor heating does have a very low temperatur delay (no floor screed above the water pipes).
My water temperature varies between 30 and 40 C.
I'm running the system in LOW ENERGY mode & Optimum start/stop and the temperatur controll works fine.
I got just issues with starting in the morning several hours too early.
Just after replacing the profile setting in the wall box several times did solve my problem.
I don't have any evidence, but it looks to me as if I had to over write the old setting a couple of times until my WTH-2 did finally accept it and was setting the temperature according my requirements.
BR,
Uli
>500 Kanäle in ca. 100 Geräten / CCU2 als LAN GW / Tinker S mit 3.73.9.20231130 produktiv.
Weiterhin über Cat5 abgesetztes HM-MOD-RPI-PCB Modul zum optimalen Antennenstandort -
3 HmIP AP Systeme mit > 30 + 40 + 15 Komponenten aufgebaut und fortlaufender Support.
1 HmIP AP mit knapp 40 Komponenten (Klimaregelung in einem Appartmenthaus/FB Heizung)
Wärmebedarfssteuerung mehrerer Buderus Systeme über HM und HmIP
Administrator der neuen User Map v.2
https://t1p.de/HMmap