Hello,
I have HomeMatic IP CCU3 with HMIP-PSM socket and HMIP-PSM thermostat I want to control the gas heater using ti creating program that will switch on the gas heater when it is less than +12 and switch it off when it is more than +15. The original program is not possible to use otherwise gas heater will be spoiled by the continuous switch on and off.
I am a newbie to CCU3 and would be gladful for step by step tutorial.
Thanks in advance
Homematic ССU program for gas heater
Moderator: Co-Administratoren
- Baxxy
- Beiträge: 11027
- Registriert: 18.12.2018, 15:45
- System: Alternative CCU (auf Basis OCCU)
- Hat sich bedankt: 631 Mal
- Danksagung erhalten: 2284 Mal
Re: Homematic ССU program for gas heater
It's just simple Logic.
Try this as template: A: Temperature Sensor
B: Actuator
Try this as template: A: Temperature Sensor
B: Actuator
Grüße... Baxxy
- Raspberry Pi 4 als Homematic-Zentrale - Tipps und Informationen
- Analysescript für genutzte Funk-Adressen, Funkmodul-Hardware und Zentralen Hardware
- NANO CUL 868MHz - Stick zum AskSin Analyzer XS umflashen (Anleitung für ArduinoIDE unter Windows)
- Firmware Updates für IP-Aktoren / Sensoren... Info's, Tipps und Sonstiges
- CCU funkt nicht - CarrierSense (CS) Probleme erkennen und lösen