Motion sensor HmIP-SMI programming

[szz743]

Hello,

I'm struggling to make HmIP-SMI activate script consistently when motion is detected.
The scripts gets activated the first time motion is detected but the next detection does not always activate the script,
Basically I need to trigger a script once every minute or 2 or some other interval between 1 and 3 minutes reliable as long as motion sensor detects motion during that interval.
Experimented with the settings a lot, checked that the sensor actually detects the motion by using LED.

My current sensor settings and programming are on the pictures. 70% of the time script is activated in 60-90 seconds after the first activation, but in other cases the second or third activation does not occur at all.

Am I doing it right? Is there some other way to make script activation reliable?
I know it's a bad idea to make loops and delays in the script in the script, so I do not do that, although that would be the easiest solution.

I hope someone can help me.
thanks!

[szz743]

Anyone? Anything? Is is about duty cycle?

thanks!