I have the HM-MOD-RPI-PCB with OCCU working fine with my Pi2 (I posted the steps for that a while back here: http://homematic-forum.de/forum/viewtop ... 64#p278958 )
Now I wanted to set up another Pi with another HM-MOD-RPI-PCB and OCCU. This time I got a Pi3. I have installed HM-MOD-RPI-PCB with OCCU exactly the same way but it does not get recognized by the Pi3. When I look at the startup log I see the following messages:
Code: Alles auswählen
Jan 31 21:56:42 top update-coprocessor: CCU2CommControllerMod::sendSystemCommand(): faild
Jan 31 21:56:47 top last message repeated 2 times
Jan 31 21:56:48 top update-coprocessor: CoprocessorUpdate::startApplication():Could not start Coprocessor application.
Jan 31 21:56:48 top update-coprocessor: Could not start Application, maybe no application on device, do update with dummy Version: 0.0.0
Jan 31 21:56:48 top update-coprocessor: Update necessary, installed: 0.0.0, avaiable 1.4.1
Jan 31 21:56:50 top update-coprocessor: CCU2CommControllerMod::sendSystemCommand(): faild
Jan 31 21:56:51 top update-coprocessor: CCU2CommControllerMod::startCoprocessorAppThreadFunction(): Trying to send SYSTEMCMD_STARTBOOTLOADER failed 3 times.
Jan 31 21:56:51 top update-coprocessor: CCU2CommControllerMod::sendSystemCommand(): faild
Jan 31 21:56:56 top last message repeated 2 times
Jan 31 21:56:58 top update-coprocessor: CCU2CommControllerMod::startCoprocessorAppThreadFunction(): Trying to send SYSTEMCMD_STARTBOOTLOADER failed 3 times.
Jan 31 21:57:01 top update-coprocessor: CoprocessorUpdate::startBootloader():Could not start Coprocessor bootloader.
Jan 31 21:57:05 top update-coprocessor: CCU2CommControllerMod::sendSystemCommand(): faild
Jan 31 21:57:15 top rfd: CCU2CommController::init(): Init failed. Cannot start coprocessor application.
Jan 31 21:57:16 top rfd: () CCU2CommController::setCSMACAEnabled(): Error disabling CSMA/CA.
Jan 31 21:57:16 top rfd: No BidCoS-Interface available
(PS I tried the HM-MOD-RPI-PCB board on my Pi2 and it works there)
(PS2 replies in German is fine