Code: Alles auswählen
C H A N G E L O G
-----------------
Please note: Only use the firmware file in connection with the current software-version of the CCUx!
Device: HmIP-FROLL - Homematic IP Shutter Actuator for flush mount
Company: eQ-3, Maiburger Str. 29, 26789 Leer, Germany
Version 1.10.16 - 2023-05-04
--------------------------------------------------------------
** Improvement
* Execute function "Enable operation within one end position to manually solve any error" only by a long button press
Version 1.10.12 - 2022-12-05
--------------------------------------------------------------
** Bugfix
* If the device is restarted while overtemperature error the first statusinfo after restart doesn't signalize an error
* A long keypress release leads to longer run time than the previous ones if the driving time is shorter than the long keypress repetition time
* After a long keypress the actor runs longer than the set driving time
* Section of virtual channels remains in "Move up/down reference run" if all three virtual channels are triggered by Direct Execution Command at startup
* A command triggered by weekprogram or internal link is handled by the virtual channels although an error is active
* Wrong evaluation of the event counter with multiple links between sensor and actuator
** Improvement
* The level values 201 (last value) and 202 (don't care) to a virtual channel shall be directly passed through to the real channel
* Changing driving directions with HmIP UP actuators via parameters
* HmIP actuators with default links as button pair, should also have ABORT_EVENT_SENDING_CHANNELS as default in pairs
* The time information telegram does not contain a note about the sommer / winter time change
* Enable operation within one end position to manually solve any error
* Switch from external to internal oscillator
Version 1.8.12 - 2019-09-03
--------------------------------------------------------------
** Bugfix
* negative coordinates are not handled correctly
* incorrect data type order for error status info message
* default profile for long keypresses is useless
* missing rf connection leads to stop of local operation at long key presses
* bug in the creation of direct execution command for the weekprogram
* actuators trigger, due to the astro function, one hour delayed or prematurely on the day of the time changeover
* HmIP radio shutter and blind actuators can be made to send DeviceInclusions again by a RetriggerDeviceInclusion Request, although this function was only intended for Wired devices
* If the switch-on and switch-off times in the Easy Profile are set to "Not active" at the same time, the device hangs up
* Shutters and blinds with longer driving times do not reach end position by short movements (very small values for MAX_TIME_FIRST_DIR)
* Device does not work correctly after overtemperature was detected
** Improvement
* added parameter DELAY_COMPENSATION to give the user the opportunity to use motors
with greater delay time between switching the relay and start of motor movement.
* new parameter to disable messages to the AC
* new operation mode for wired devices
* event counter validation expanded to range
* all powerup parameters are supported now
* Improve switch command functionality by new implementation of local loopback, adding command cancelation and using node sending functionality
* Modify event counter check to meet current specification
* If possible, send multicasts only to PARTNER_ALL_WIRED_DEVICES instead of to PARTNER_ALL_DEVICES
Version 1.2.0 - 2017-05-18
--------------------------------------------------------------
** First release