ich hab gerade ein bisschen Spieltrieb und Home Assistant mit Raspberrymatic als Add-on in einer VM auf meinem Proxmox Testsystem installiert. Den USB-Port vom RPI-RF-MOD habe ich durchgereicht - leider wird das Modul nicht erkannt:
Code: Alles auswählen
Mounting /data as /usr/local (Home Assistant Add-On): OK
Identifying onboard hardware: oci, OK
Initializing RTC Clock: onboard, OK
Running sysctl: OK
Checking for Factory Reset: not required
Checking for Backup Restore: OK: backup successfully restored
Initializing System: OK
Starting logging: OK
Init onboard LEDs: init, OK
Starting irqbalance: OK
Starting network: eth0: link up, fixed, firewall, inet up, 172.30.33.0, OK
Identifying Homematic RF-Hardware: HmRF: none, HmIP: none, OK
Updating Homematic RF-Hardware: no GPIO/USB connected RF-hardware found
Starting hs485dLoader: disabled
Starting xinetd: OK
Starting eq3configd: OK
Starting lighttpd: OK
Starting ser2net: disabled
Starting ssdpd: OK
Starting sshd: OK
Starting ha-proxy: OK
Starting NUT services: disabled
Initializing Third-Party Addons: OK
Starting LGWFirmwareUpdate: ...OK
Setting LAN Gateway keys: OK
Starting hs485d: disabled
Starting multimacd: not required
Starting rfd: no BidCos-RF hardware found
Starting HMIPServer: ...OK
Starting ReGaHss: .OK
Starting CloudMatic: OK
Starting Third-Party Addons: OK
Starting crond: OK
Setup onboard LEDs: booted, OK
Auf dem selben Proxmox-System ist meine OVA-Raspimatic-Testversion mit dem selben Funkmodul installiert, was problemlos funktioniert. Auch hier ist der USB-Port des RPI-RF-MOD druchgereicht. Natürlich laufen beide VM nicht parallel...
Danke Euch