Jetzt ist das PDF aktualisiert.
Die normale Ausgabe kommt schon, wenn ich einen Sketch per ISP flashe.
Beim Flashen kommt sowas:
Code: Alles auswählen
Using Port : COM4
Using Programmer : arduino
Overriding Baud Rate : 57600
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xde
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x3a
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x34
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x35
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x31
EDIT:
jetzt geht es. Offensichtlich hat der DTR-Pin an meinem FTDI-Board nicht die beste Verbindung gehabt...