Schon merkwürdig, ich hatte es Abends noch einmal probiert und da klappte es sofort. Verstehe ich zwar nicht, da ich nix anders gemacht habe, aber egal er verrichtet seinen Dienst einwandfrei
Ich wollte auf der Platine HM-UNI-SEN-BATT einen BH1750 verwenden, dazu habe ich mir die Anleitung von Technikkram angeschaut und entsprechend gelötet (mit LED und Widerstand).
Die Fuses habe ich im Vorfeld mit dem Diamex gesetzt.
Anschließend habe ich den LDO und die Power-LED entfernt und wollte dann den Sketch HM-Sen-LI-O per USB-TTL-Adapter auf 3,3V aufspielen. Doch das funktioniert nicht. Ich dachte zuerst, Mist, Hardware geschrottet beim Ablöten, aber als ich vorhin den bootloader von der AskSinpp-Seite per avrdude aufspielte sah das folgendermaßen aus:
Code: Alles auswählen
G:\AVRDude>avrdude.exe -C G:\AVRDude\avrdude.conf -p m328p -P com5 -c stk500v2 -V -U flash:w:ATmegaBOOT_168_atmega328_pro_8MHz.hex
avrdude.exe: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% -0.00s
avrdude.exe: Device signature = 0x1e950f (probably m328p)
avrdude.exe: NOTE: "flash" memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude.exe: erasing chip
avrdude.exe: reading input file "ATmegaBOOT_168_atmega328_pro_8MHz.hex"
avrdude.exe: input file ATmegaBOOT_168_atmega328_pro_8MHz.hex auto detected as Intel Hex
avrdude.exe: writing flash (32652 bytes):
Writing | ################################################## | 100% 0.07s
avrdude.exe: 32652 bytes of flash written
avrdude.exe: safemode: Fuses OK (E:FF, H:D2, L:FF)
avrdude.exe done. Thank you.
Code: Alles auswählen
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x5d
Problem beim Hochladen auf das Board. Hilfestellung dazu unter http://www.arduino.cc/en/Guide/Troubleshooting#upload.