Das hier:hobbyquaker hat geschrieben:was gibt denn ein
Code: Alles auswählen
ls /dev/ttyAMA*
bei Dir aus?
Code: Alles auswählen
root@Test-Pi3:~# ls /dev/ttyAMA*
/dev/ttyAMA0
oder: Es ist nicht das ttyAMA das du suchst - Möge die Macht mit dir sein.
och mehr unnötige Info:
Code: Alles auswählen
root@Test-Pi3:~# dmesg | grep tty
[ 0.000000] Kernel command line: 8250.nr_uarts=1 dma.dmachans=0x7f35 bcm2708_fb.fbwidth=656 bcm2708_fb.fbheight=416 bcm2709.boardrev=0xa02082 bcm2709.serial=0xaf327832 smsc95xx.macaddr=B8:27:EB:32:78:32 bcm2708_fb.fbswap=1 bcm2709.uart_clock=48000000 vc_mem.mem_base=0x3dc00000 vc_mem.mem_size=0x3f000000 dwc_otg.lpm_enable=0 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline fsck.repair=yes rootwait
[ 0.001283] console [tty1] enabled
[ 0.267935] 3f215040.uart: ttyS0 at MMIO 0x3f215040 (irq = 29, base_baud = 50000000) is a 16550
[ 0.927309] 3f201000.uart: ttyAMA0 at MMIO 0x3f201000 (irq = 83, base_baud = 0) is a PL011 rev2
Rainer