Today I have connected HMiP WHS2 to the system and it works just great, exactly as I wanted. I have used channel number 2 (Thanks Sergo for this explaining picture) for non potential switching for my boiler (just in case you want to know it's Protherm Ray 14K)
In the app I have selected mode "Heat demand for rooms" and voila - works perfect
Hi, I installed today WHS2, works almost great but I have 3-4 minutes delay, when turning heating on with thermostat till boiler starts heating, same for lowering temperature down few degrees below actual temperature then after 3-4 minutes boiler turns off heating.
Do you have same or INSTANT switch on/off?
Thanks
... I have 3-4 minutes delay...Do you have same or INSTANT switch on/off?
Thanks
I would guess this may relate with your settings in direct device connection, for me it switching instantly, sometimes with minor delays 1-15 sek.
P.S. that is why I added light indication...
This morning I have had a different experience - I have turned my heating in living room from programmed 16°C to 23°C and the switch on of the boiler was almost instant (like 15 seconds)...
So I guess WHS2 somehow evaluates difference between required and actual temperature and based on that decides, how fast it will switch on the heating