HMip thermostat with HM actuator

[acefx]

Hi everybody, i'm completely new to Homematic and i need to setup the electric heating device in my appartment.
By the way i'm from switzerland, but not german speaking ( French / english & italian ). I'm also a power user of some other domotic solution like jeedom / domoticz & openHab.

Like the subject says, i would like to know if it's possible in any possible way to "drive" an HM electric actuator like HM-LC-SW4-DR-2 with an Homematic-IP Thermostat like the HmIP-WTH-2.

Iknow after hours of reading that you can't make a direct connection between HM & HM-IP device, but isn't it possible to do it via some virtual device into a CCU3 ?
Why do i want to do this kind of complexity ? Simple the 4 Channel actuator i got is cheap & already installed into my house. The non HMIP thermostat are really hard to find in switzerland.


Thanks for your answer.

[Roland M.]

Hello and welcome to the forum!

Like the subject says, i would like to know if it's possible in any possible way to "drive" an HM electric actuator like HM-LC-SW4-DR-2 with an Homematic-IP Thermostat like the HmIP-WTH-2.

Yes, but it's rather difficult to rebuild the full logic of a direct device connection with programs and scripts.
I'd rather go for a HM thermostat.

The non HMIP thermostat are really hard to find in switzerland.

The Swiss branch of ELV has it on stock:
https://ch.elv.com/homematic-funk-wandt ... 7963&c=412


Roland

[acefx]

Ok great ! I've found also some thermostat on Conrad.
Another question :
Is it possible to manage a virtual thermostat with an actuator on one side and a temperature sensor on the other ?
I ask that because some rooms like toilet need a temperature regulation and schedule but don't deserve a standalone thermostat...,:+)


a great thanks for your help