habe piVCCU3 3.53.34 frisch auf einem PI4 4GB installiert. Rasbian Buster, dann IOBroker und piVCCU3 drauf. Hat alles super geklaptt und lief.
Dann habe ich mein Backup von meiner alten pivCCU auf PI3 1GB (3.47.10) laden wollen und danach war die pivCCU3 nicht mehr über die IP4 Adress zu erreichen!? Ohne Neustart o.ä. .
Es klappte das wiederanmelden, was die HM Software verlangt, nicht mehr, sodass nur ein Neustart bieb!
Danach das oben beschriebene Phänomen! LAN war verbunden, DHCP lief.
alles IO (direkt nach Neuinstallation:
Code: Alles auswählen
pi@raspberrypi:~ $ sudo pivccu-info
piVCCU version: 3.53.34-49
Kernel modules: Available
Raw UART dev: Available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: HM-MOD-RPI-PCB
Board serial: PEQ0530411
Radio MAC: 0x6A63E6
HMIP Hardware: HM-MOD-RPI-PCB
SGTIN: 3014F711A061A7D8A9917FEB
Radio MAC: 0xBC15C2
State: RUNNING
PID: 1975
IP: 192.168.178.46
CPU use: 16.02 seconds
BlkIO use: 148.00 KiB
Link: vethpivccu
TX bytes: 13.74 KiB
RX bytes: 48.59 KiB
Total bytes: 62.33 KiB
pi@raspberrypi:~ $ sudo brctl show
bridge name bridge id STP enabled interfaces br0 8000.dca632de6e84 no eth0 vethpivccu
pi@raspberrypi:~ $
Code: Alles auswählen
pi@raspberrypi:~ $ sudo pivccu-info
piVCCU version: 3.53.34-49
Kernel modules: Available
Raw UART dev: Available
Rasp.Pi UART: Assigned to GPIO pins
HMRF Hardware: HM-MOD-RPI-PCB
Board serial: PEQ0530411
Radio MAC: 0x6A63E6
HMIP Hardware: HM-MOD-RPI-PCB
SGTIN: 3014F711A061A7D8A9917FEB
Radio MAC: 0xBC15C2
State: RUNNING
PID: 4003
IP: 2a02:908:1c17:d400:c81a:86ff:feb5:f054
CPU use: 12.48 seconds
BlkIO use: 112.00 KiB
Link: vethpivccu
TX bytes: 602 bytes
RX bytes: 16.72 KiB
Total bytes: 17.30 KiB
pi@raspberrypi:~ $ sudo brctl show
bridge name bridge id STP enabled interfaces br0 8000.dca632de6e84 no eth0 vethpivccu
pi@raspberrypi:~ $
Gruß
Timo