auch ich habe wie viele das Problem, daß WEBUI wegen der Sommerzeit-Umstellung seit gestern morgen nicht mehr läuft.
Also wollte ich die FW upgraden, wie empfohlen von jmaus unter viewtopic.php?f=26&t=42887&hilit=zeitum ... 10#p426695. Jedoch startet der YAHM-Container nach dem Upgrade nicht mehr:
Code: Alles auswählen
pi@raspberrypi-1:~ $ sudo yahm-ctl update
New CCU2 firmware: 2.31.25 available, update with 'yahm-lxc update' possible
Updating YAHM installation, for updatate CCU2 please use 'yahm-lxc update'
Fetching submodule share/tools/Network-Interfaces-Script
Fetching submodule share/tools/arm-board-detect
Fetching submodule share/tools/rpi-source
Already up-to-date.
Updating all YAHM modules
Betrete 'share/tools/Network-Interfaces-Script'
Von https://github.com/leonsio/Network-Interfaces-Script
* branch master -> FETCH_HEAD
Already up-to-date.
Betrete 'share/tools/arm-board-detect'
Von https://github.com/leonsio/arm-board-detect
* branch master -> FETCH_HEAD
Already up-to-date.
Betrete 'share/tools/rpi-source'
Von https://github.com/notro/rpi-source
* branch master -> FETCH_HEAD
Already up-to-date.
Betrete 'share/tools/Network-Interfaces-Script'
Betrete 'share/tools/arm-board-detect'
Betrete 'share/tools/rpi-source'
Updating CCU2-FW archive
YAHM version 1.9 found
pi@raspberrypi-1:~ $ sudo yahm-ctl info
New CCU2 firmware: 2.31.25 available, update with 'yahm-lxc update' possible
YAHM Version: 1.9
CCU2 Version: 2.27.8
LXC container information
Name: yahm
State: RUNNING
PID: 18341
IP: 10.8.0.191
IP: 192.168.0.45
IP: 2003:c6:3bf2:f700:4849:43ff:fe49:79a1
CPU use: 23.88 seconds
BlkIO use: 200.00 KiB
Memory use: 69.39 MiB
KMem use: 4.10 MiB
Link: vethRJ8UJ4
TX bytes: 510.65 KiB
RX bytes: 186.57 KiB
Total bytes: 697.22 KiB
pi@raspberrypi-1:~ $ sudo yahm-lxc -f update
New CCU2 firmware: 2.31.25 available, update with 'yahm-lxc update' possible
Installed version: 2.27.8
Available version: 2.31.25
Trying to create a config-backup from installed version 2.27.8, calling: 'yahm-backup data_backup' script
New CCU2 firmware: 2.31.25 available, update with 'yahm-lxc update' possible
Clean up TMP directory
Ask Rega to save the DOM
Creating Backup from /usr/local folder
Creating Homematic backup file
Clean up
STATUS: CCU2 Backup was successfully created: /tmp/YAHM/homematic-ccu2-1522155654.sbk
Backup old LXC config
Backup installed modules
INFO: Config backup file location: /tmp/YAHM_update/yahm/homematic-ccu2-1522155654.sbk
Creating full backup from installed version 2.27.8, calling: 'yahm-backup full_backup' script
New CCU2 firmware: 2.31.25 available, update with 'yahm-lxc update' possible
Trying to stop yahm container
Creating new backup from yahm version 2.27.8
tar: yahm/root/tmp/udev/control: Socket ignoriert
STATUS: Backup was successfully created: /tmp/YAHM/yahm_backup-2.27.8.tgz
Please start yahm container with 'sudo yahm-ctl -n yahm start' manually
INFO: Full backup file location: /tmp/YAHM_update/yahm/yahm_backup-2.27.8_20180327.tgz
Delete old YAHM Container version: 2.27.8
Backup virtual SD-Card
Entering force mode
Deleting installed YAHM container: yahm version: 2.27.8 To cancel this operation type CTRL+C you have 5 seconds...
... too late ;)
Stopping LXC container
yahm is not running
Container can not be found or is not running
Deleting LXC container
Clean up
Create new YAHM Container version: 2.31.25
ATTENTION: FORCE-Switch is used, actual instance will be overwritten
Creating new lxc container name: yahm, version 2.31.25
Downloading CCU Firmware
Extracting firmware
Extract ubi image
Writing to: /var/lib/lxc/yahm/root
INFO: No patches for version 2.31.25 found, trying to use old patches from 2.29.23
Cleanup CCU2 source
Applying patch
patch: **** Can't open patch file /opt/YAHM/share/firmware/patches/2.29.23.patch : No such file or directory
Applying scripts
sh: 0: Can't open /opt/YAHM/share/firmware/scripts/2.29.23.sh
Creating SD card
Clean Up
Creating lxc config file
Container version 2.31.25 is created, please use 'yahm-ctl -n yahm start' to start and 'yahm-ctl -n yahm join' for console access
For network configuration see yahm-network script
Restoring old LXC config
Trying to restore old CCU2 backup, calling 'yahm-backup data_restore'
Clean up TMP directory
Extracting CCU2 backup
WARNING: /usr/local folder with all settings inside yahm container will be removed. You have 5 seconds to cancel this operation...
... to late ;)
Extracting Backup Data
STATUS: Backup version 2.27.8 was successfully restored into yahm container version 2.31.25
Please start yahm container with 'sudo yahm-ctl -n yahm start' manually
Starting yahm LXC container
Restoring old installed modules
Restoring hm-mod-rpi-pcb Module
Executing hm-mod-rpi-pcb module_install()
Found hardware: Raspberry Pi 3
Trying to disable bluetooth on Raspberry Pi 3 to use HM-MOD-RPI-PCB
Trying to disable serial console
Serial already disabled
Preparing devices inside LXC container
Creating device /dev/ttyAMA0...
Creating symlink /dev/mmd_bidcos...
Creating symlink /dev/ccu2-ic200...
Preparing modification rfd.conf...
[Interface 0] block found in rfd.conf checking it...
Modification rfd.conf done.
HM-MOD-RPI-PCB was installed successfully, please restart YAHM to apply changes
Trying to start service
Synchronizing state for hm-mod-rpi-pcb.service with sysvinit using update-rc.d...
Executing /usr/sbin/update-rc.d hm-mod-rpi-pcb defaults
Executing /usr/sbin/update-rc.d hm-mod-rpi-pcb enable
STATUS: Module hm-mod-rpi-pcb was successfully installed
Restoring regahss-beta Module
Specified module can not be found
STATUS: Update was successfully new version is: 2.31.25
STATUS: Old config backup file: /tmp/YAHM_update/yahm/homematic-ccu2-1522155654.sbk
STATUS: Old full lxc backup file: /tmp/YAHM_update/yahm/yahm_backup-2.27.8_20180327.tgz
pi@raspberrypi-1:~ $ sudo yahm-ctl info
YAHM Version: 1.9
CCU2 Version: 2.31.25
LXC container information
Name: yahm
State: STOPPED
pi@raspberrypi-1:~ $ sudo yahm-ctl start
Starting yahm LXC container
pi@raspberrypi-1:~ $ sudo yahm-ctl info
YAHM Version: 1.9
CCU2 Version: 2.31.25
LXC container information
Name: yahm
State: STOPPED
pi@raspberrypi-1:~ $ sudo yahm-ctl -v start
Starting yahm LXC container in debug mode
lxc-start: tools/lxc_start.c: main: 366 The container failed to start.
lxc-start: tools/lxc_start.c: main: 368 To get more details, run the container in foreground mode.
lxc-start: tools/lxc_start.c: main: 370 Additional information can be obtained by setting the --logfile and --logpriority options.
pi@raspberrypi-1:~ $ sudo yahm-module installed
Installed modules:
hm-mod-rpi-pcb GPIO Funkmodul für Raspberry Pi2/3
pi@raspberrypi-1:~ $ sudo yahm-module available
Available modules:
cuxd CuxD 1.7 for Yahm
hm-lan-fake-gw HM-MOD-RPI-PCB as HM LAN Gateway inside host
hm-mod-rpi-pcb GPIO Funkmodul für Raspberry Pi2/3
homebridge Installiert Homebridge zur Anbindung von Apple HomeKit an die CCU
homematic-ip Homematic IP Unterstützung
meinhomematic Unterstützung für Mein Homematic
Code: Alles auswählen
pi@raspberrypi-1:/var/log/yahm $ sudo yahm-backup -f -d /nas/backup/ccu2_backup_full_pi1_2018-03-14.tgz full_restore
Clean up TMP directory
Extracting LXC backup
yahm is not running
No running lxc instance found, continue
Moving backup to /var/lib/lxc/yahm
Clean up
STATUS: YAHM version 2.27.8 was successfully restored
Please start yahm container with 'sudo yahm-ctl -n yahm start' manually
pi@raspberrypi-1:~ $ sudo yahm-ctl start
New CCU2 firmware: 2.31.25 available, update with 'yahm-lxc update' possible
Starting yahm LXC container
pi@raspberrypi-1:~ $ sudo yahm-ctl info
New CCU2 firmware: 2.31.25 available, update with 'yahm-lxc update' possible
YAHM Version: 1.9
CCU2 Version: 2.27.8
LXC container information
Name: yahm
State: RUNNING
PID: 18341
IP: 192.168.0.45
IP: 2003:c6:3bf2:f700:4849:43ff:fe49:79a1
CPU use: 2.53 seconds
BlkIO use: 88.00 KiB
Memory use: 7.16 MiB
KMem use: 3.64 MiB
Link: vethRJ8UJ4
TX bytes: 34.49 KiB
RX bytes: 18.82 KiB
Total bytes: 53.32 KiB
Ich verzweifle inzwischen nach stundenlanger Fehlersuche und Probieren . Bitte um Eure Hilfe.
Viele Grüße
Roland